[Cameron Littlejohn]

Well I took the bar off to straighten it today and the pins that are in the inner shoe aree being a lil stubborn lol I worked on one pin for four hours, I got the front one our but I can not get the back one to budge. I guess I’m gonna cut the pin into and drill it out once the shoe is off. Both the pins are wore out in the center so it needs new pins anyways. Any suggestions to get the back pin out? I don’t wanna heat it for the housing is cast and I’m afraid to bust it.

[Cameron Littlejohn]

Yea john I searched that stuff on google and it looks like really good stuff! Ill have to get some in the near future and try it out.

[Cameron Littlejohn]

Ok I appreciate it ill have to check it out. I went and got the mower and its in pretty good shape, there are no cracks like he said but the bar is bent a little so I’m gonna heat it up and bend it back straight, and it needs a new pitman arm and the pitman latch is missing but I have an extra oone. But other than that other than soaking it in some diesel fuel or oil and cleaning and sharpening the blade a bit its in good shape. Ill have to make a set of shafts too and a front truck before spring.

[Cameron Littlejohn]

Thanks for all the info! I had a problem this morning, my clydesdale was tryin to get the rest of the green grass leanin over the fence and brove about 5 wooden posts and ran his fence over and got out lol luckily our driveway has a gate too so he couldn’t get out. I’ve been drillin and setting new posts all day, I’m still gonna run up and get it tomorrow tho. I’m excited, ill have to look on the forum for the part numbers on those seals. Thank y’all!

[Cameron Littlejohn]

Thank you for the welcoming. I’m sure ill have plenty of questions in the near future. I have to look in the equipment part of the forum but most of my equipment needs to be converted to one horse instead of. A team. My mower is only 3 and a half foot but I’m not sure how to hook the discer up right yet lol

[Author]

Posts