DAPNET Forums Archive › Forums › Equipment Category › Equipment Fabrication › neck yoke length
- This topic has 2 replies, 2 voices, and was last updated 12 years ago by
PeytonM.
- AuthorPosts
- April 23, 2013 at 12:11 pm #78665
PeytonM
ParticipantOk I have two harnesses one is a double neck yoke and the other has a martengale. Anyone know why the double ny had a yoke on the pole about 3 ft long and a marrtenggale is about 2ft? Thanks!
April 25, 2013 at 10:25 am #78709Donn Hewes
KeymasterI am unclear on the terms you are using? Double neck yoke? Is perhaps a neck yoke with two jockey yokes (my terms – sorry).? or just a three foot yoke made for a team (not usually refered to as a double neck yoke). In that case the three foot neck yoke matches if you use a three foot double tree behind the horses. In any case your yoke and evener should match or be close as they aline the front end and the back of the animals. A martengale I think of as a harness with no collar and a breast strap for a horse pulling a light rig. I might easily be wrong in this as it is not a setup I am that familiar with. As for the two foot yoke; That may or may not go with the martengale and it sounds like a jockey yoke.
Peyton, I didn’t modify your post – it just thinks I did! Still learning, D
The use of jockey yokes (short – individual yokes) will depend on the type of harness you have. A side backer or a D ring harness will use a short yoke along with the three foot yoke; while a belly backer will not.
April 30, 2013 at 10:47 am #79365PeytonM
ParticipantNot a jocky stick, it is a neck yoke, everyone I know calls them double neck yoke or double backers. Or sidebacker. Its the “old school” stuff. Martengales replaced them.
- AuthorPosts
- You must be logged in to reply to this topic.